(Click on any image for the larger version)

The seller claims it was used less than 10 hours in its life, but they must have been some abusive hours.  There is a chunk missing out of the table (seen in the left middle picture), bent/stripped/loose/missing handles and knobs, and a scored MT3 to JT33 drill chuck arbor.  I need to strip the machine, clean it up, and put everything back together before I take my own pictures. (Hopefully most of the slop will be gone when I'm done!)

 

Grr, post A which holds two of the leadscrew gears worked its way out of the hole it was press fit in.  I think it was caused by binding between the change gear plate (Red) and the back of the spline that holds gear D (Green).  I should be able to get rid of this binding by putting shims between the spacer (Blue) and the change gear plate.